K0FTT Automobiles

My position About ☰

reset

LW2DHT-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object LW2DHT-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1765338968	6 Count	5 Count	5 Count
1765337165	3 Count	3 Count	3 Count
1765335360	1003 Count	735 Count	724 Count
1765333557	999 Count	732 Count	721 Count
1765331753	995 Count	729 Count	718 Count
1765329949	991 Count	726 Count	715 Count
1765328145	988 Count	724 Count	713 Count
1765317368	968 Count	710 Count	699 Count
1765315565	965 Count	708 Count	697 Count
1765313761	962 Count	706 Count	695 Count
1765311957	956 Count	701 Count	690 Count
1765310154	953 Count	699 Count	688 Count
1765308350	950 Count	697 Count	686 Count
1765306546	946 Count	694 Count	683 Count
1765304743	943 Count	692 Count	681 Count
1765302939	939 Count	690 Count	679 Count
1765301136	936 Count	688 Count	677 Count
1765299332	932 Count	685 Count	674 Count
1765297529	929 Count	683 Count	672 Count
1765295768	926 Count	681 Count	670 Count
1765293964	923 Count	679 Count	668 Count
1765292161	920 Count	677 Count	666 Count
1765290358	916 Count	674 Count	663 Count
1765288554	912 Count	671 Count	660 Count
1765286751	909 Count	669 Count	658 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)