K0FTT Automobiles

My position About ☰

reset

SQ9IDT-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9IDT-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1765461304	53 Count	339 Count	51 Count
1765459513	35 Count	211 Count	34 Count
1765457703	18 Count	112 Count	18 Count
1765455902	168 Count	1038 Count	156 Count
1765452301	130 Count	781 Count	120 Count
1765450500	110 Count	677 Count	101 Count
1765448699	91 Count	606 Count	83 Count
1765445098	58 Count	359 Count	52 Count
1765443304	36 Count	233 Count	35 Count
1765441504	17 Count	102 Count	17 Count
1765439703	244 Count	1098 Count	227 Count
1765437909	225 Count	995 Count	209 Count
1765436102	207 Count	885 Count	192 Count
1765434301	189 Count	771 Count	175 Count
1765432500	170 Count	688 Count	157 Count
1765428899	136 Count	481 Count	125 Count
1765427098	118 Count	419 Count	108 Count
1765425307	98 Count	345 Count	89 Count
1765423509	79 Count	270 Count	72 Count
1765421703	57 Count	185 Count	55 Count
1765419902	38 Count	124 Count	37 Count
1765418102	18 Count	64 Count	18 Count
1765416301	168 Count	1022 Count	151 Count
1765414500	150 Count	952 Count	134 Count
1765412700	123 Count	886 Count	108 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)