K0FTT Automobiles

My position About ☰

reset

VK3XEM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object VK3XEM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1765472163	740 Count	159 Count
1765471259	739 Count	159 Count
1765470355	738 Count	159 Count
1765469451	737 Count	159 Count
1765468547	736 Count	159 Count
1765467643	735 Count	158 Count
1765466739	734 Count	157 Count
1765465835	733 Count	156 Count
1765464931	732 Count	156 Count
1765464027	731 Count	155 Count
1765463122	730 Count	155 Count
1765462322	729 Count	153 Count
1765461418	728 Count	152 Count
1765460514	727 Count	151 Count
1765459609	726 Count	150 Count
1765458704	725 Count	150 Count
1765457800	724 Count	150 Count
1765456896	723 Count	149 Count
1765455995	722 Count	149 Count
1765455087	721 Count	148 Count
1765454183	720 Count	147 Count
1765453279	719 Count	146 Count
1765452375	718 Count	146 Count
1765451471	717 Count	146 Count
1765450567	716 Count	146 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)