K0FTT Automobiles

My position About ☰

reset

OK1OBR-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK1OBR-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1766457162	72 Count	396 Count
1766455358	71 Count	394 Count
1766453555	70 Count	392 Count
1766451797	69 Count	391 Count
1766449993	66 Count	386 Count
1766448189	65 Count	385 Count
1766446386	64 Count	383 Count
1766444583	63 Count	381 Count
1766442777	60 Count	380 Count
1766440973	59 Count	380 Count
1766439169	58 Count	378 Count
1766437366	56 Count	376 Count
1766435561	55 Count	370 Count
1766433758	54 Count	358 Count
1766431954	53 Count	352 Count
1766430198	52 Count	348 Count
1766428394	50 Count	341 Count
1766426591	49 Count	340 Count
1766424788	48 Count	336 Count
1766422984	47 Count	333 Count
1766421177	45 Count	330 Count
1766419373	44 Count	323 Count
1766417569	43 Count	323 Count
1766415766	41 Count	321 Count
1766413961	39 Count	319 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)