K0FTT Automobiles

My position About ☰

reset

SP1GDK-6 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP1GDK-6. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1765321329	981 Count	37 Count
1765320723	980 Count	37 Count
1765320116	979 Count	37 Count
1765319510	978 Count	37 Count
1765318903	977 Count	37 Count
1765318297	976 Count	37 Count
1765317691	975 Count	37 Count
1765317085	974 Count	37 Count
1765316478	973 Count	37 Count
1765315872	972 Count	37 Count
1765315266	971 Count	37 Count
1765314659	970 Count	37 Count
1765314283	969 Count	37 Count
1765313677	968 Count	37 Count
1765313071	967 Count	37 Count
1765312464	966 Count	37 Count
1765311858	965 Count	37 Count
1765311252	964 Count	37 Count
1765310646	963 Count	37 Count
1765310040	962 Count	37 Count
1765309433	961 Count	37 Count
1765308827	960 Count	37 Count
1765308221	959 Count	37 Count
1765307615	958 Count	37 Count
1765307009	957 Count	37 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)