K0FTT Automobiles

My position About ☰

reset

SQ4HSE-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ4HSE-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1765352945	423 Count	519 Count	332 Count
1765349344	420 Count	516 Count	330 Count
1765345744	417 Count	508 Count	328 Count
1765342143	412 Count	503 Count	324 Count
1765338542	407 Count	498 Count	320 Count
1765334942	404 Count	495 Count	318 Count
1765331341	401 Count	491 Count	316 Count
1765327740	398 Count	488 Count	314 Count
1765324138	394 Count	484 Count	311 Count
1765320537	390 Count	480 Count	308 Count
1765316937	387 Count	475 Count	306 Count
1765313336	384 Count	471 Count	304 Count
1765309735	380 Count	466 Count	301 Count
1765306134	376 Count	462 Count	298 Count
1765302533	372 Count	455 Count	295 Count
1765298932	369 Count	452 Count	293 Count
1765295332	366 Count	449 Count	291 Count
1765291731	362 Count	445 Count	288 Count
1765288129	357 Count	440 Count	284 Count
1765284528	354 Count	437 Count	282 Count
1765280927	348 Count	430 Count	277 Count
1765277327	344 Count	426 Count	274 Count
1765273726	340 Count	422 Count	271 Count
1765270125	335 Count	417 Count	267 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)