K0FTT Automobiles

My position About ☰

reset

SP5MSV-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5MSV-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1765341019	246 Count	526 Count	86 Count
1765339218	244 Count	520 Count	85 Count
1765337417	242 Count	514 Count	84 Count
1765335616	240 Count	508 Count	83 Count
1765333816	239 Count	502 Count	83 Count
1765332023	237 Count	495 Count	82 Count
1765330223	235 Count	489 Count	81 Count
1765328422	233 Count	482 Count	80 Count
1765326621	231 Count	475 Count	79 Count
1765324822	229 Count	468 Count	78 Count
1765323020	227 Count	463 Count	77 Count
1765321219	225 Count	458 Count	76 Count
1765319418	223 Count	456 Count	75 Count
1765317617	221 Count	453 Count	74 Count
1765315817	220 Count	452 Count	74 Count
1765314016	218 Count	450 Count	73 Count
1765312215	216 Count	448 Count	72 Count
1765310423	215 Count	445 Count	72 Count
1765308622	213 Count	443 Count	71 Count
1765306822	212 Count	442 Count	71 Count
1765305021	211 Count	441 Count	71 Count
1765303220	209 Count	437 Count	70 Count
1765301419	208 Count	436 Count	70 Count
1765299618	207 Count	435 Count	70 Count
1765297818	205 Count	428 Count	69 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)