K0FTT Automobiles

My position About ☰

reset

SV9KIR-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SV9KIR-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1765999376	320 Count	678 Count
1765997570	318 Count	672 Count
1765996667	317 Count	671 Count
1765995764	316 Count	670 Count
1765994029	314 Count	667 Count
1765993126	313 Count	662 Count
1765992224	312 Count	653 Count
1765991321	311 Count	650 Count
1765990417	310 Count	644 Count
1765989514	309 Count	642 Count
1765988611	308 Count	639 Count
1765987708	307 Count	637 Count
1765986805	306 Count	636 Count
1765985902	305 Count	630 Count
1765984999	304 Count	625 Count
1765984096	303 Count	624 Count
1765983193	302 Count	614 Count
1765982290	301 Count	613 Count
1765981387	300 Count	608 Count
1765980485	299 Count	607 Count
1765979582	298 Count	605 Count
1765978678	297 Count	600 Count
1765977775	296 Count	595 Count
1765976873	295 Count	593 Count
1765975969	294 Count	591 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)