K0FTT Automobiles

My position About ☰

reset

OK1LOL-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK1LOL-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1765942758	159 Count	907 Count
1765940957	158 Count	900 Count
1765939152	157 Count	893 Count
1765937349	156 Count	885 Count
1765935546	155 Count	878 Count
1765933743	154 Count	870 Count
1765931940	153 Count	863 Count
1765930137	150 Count	855 Count
1765928334	149 Count	848 Count
1765926531	148 Count	842 Count
1765924728	147 Count	835 Count
1765922960	146 Count	828 Count
1765921157	145 Count	822 Count
1765919354	144 Count	816 Count
1765917551	143 Count	809 Count
1765915748	142 Count	802 Count
1765913945	141 Count	795 Count
1765912142	140 Count	788 Count
1765910339	139 Count	781 Count
1765908536	138 Count	774 Count
1765906733	137 Count	766 Count
1765904930	136 Count	760 Count
1765903127	135 Count	753 Count
1765901360	134 Count	745 Count
1765899557	133 Count	738 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)