K0FTT Automobiles

My position About ☰

reset

SQ4VK-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ4VK-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1765421846	407 Count	71 Count	22 Count
1765420945	401 Count	70 Count	22 Count
1765420044	395 Count	70 Count	22 Count
1765419144	389 Count	69 Count	22 Count
1765418260	382 Count	69 Count	22 Count
1765417359	376 Count	69 Count	22 Count
1765416458	369 Count	69 Count	22 Count
1765415557	363 Count	69 Count	22 Count
1765414657	357 Count	69 Count	22 Count
1765413756	351 Count	67 Count	22 Count
1765412855	343 Count	66 Count	22 Count
1765411955	338 Count	65 Count	22 Count
1765411054	331 Count	65 Count	22 Count
1765410153	325 Count	65 Count	22 Count
1765409253	318 Count	65 Count	22 Count
1765408352	312 Count	65 Count	22 Count
1765407451	305 Count	65 Count	22 Count
1765406550	300 Count	62 Count	22 Count
1765405650	292 Count	62 Count	22 Count
1765404749	286 Count	61 Count	22 Count
1765403848	280 Count	59 Count	22 Count
1765402948	274 Count	57 Count	22 Count
1765402047	267 Count	56 Count	22 Count
1765401146	250 Count	45 Count	11 Count
1765400245	243 Count	44 Count	11 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)