K0FTT Automobiles

My position About ☰

reset

OK2PYA-5 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK2PYA-5. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1765426467	42 Count	9 Count	2 Count
1765424540	40 Count	9 Count	2 Count
1765422613	38 Count	9 Count	2 Count
1765420686	35 Count	7 Count	1 Count
1765418759	33 Count	6 Count	1 Count
1765416832	31 Count	6 Count	1 Count
1765414905	29 Count	6 Count	1 Count
1765412979	27 Count	6 Count	1 Count
1765411052	25 Count	6 Count	1 Count
1765408718	22 Count	6 Count	1 Count
1765406792	20 Count	6 Count	1 Count
1765404865	18 Count	6 Count	1 Count
1765402938	16 Count	5 Count	1 Count
1765401011	14 Count	5 Count	1 Count
1765399084	12 Count	5 Count	1 Count
1765397158	10 Count	4 Count	1 Count
1765395231	8 Count	4 Count	1 Count
1765393304	6 Count	4 Count	1 Count
1765391378	3 Count	3 Count	0 Count
1765389451	1 Count	2 Count	0 Count
1765389046	0 Count	2 Count	0 Count
1765387119	999 Count	282 Count	81 Count
1765385192	997 Count	280 Count	81 Count
1765383265	995 Count	280 Count	81 Count
1765381339	993 Count	278 Count	81 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)