K0FTT Automobiles

My position About ☰

reset

SQ2ODE-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2ODE-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1765330023	379 Count	644 Count
1765328222	378 Count	643 Count
1765326421	377 Count	642 Count
1765324621	376 Count	641 Count
1765322820	375 Count	640 Count
1765321020	374 Count	639 Count
1765319219	373 Count	638 Count
1765317418	372 Count	637 Count
1765315618	371 Count	636 Count
1765313817	370 Count	635 Count
1765312016	369 Count	634 Count
1765310222	368 Count	633 Count
1765308422	367 Count	632 Count
1765306621	366 Count	631 Count
1765304820	365 Count	630 Count
1765303020	364 Count	629 Count
1765301219	363 Count	628 Count
1765299419	362 Count	627 Count
1765297618	361 Count	626 Count
1765295817	360 Count	625 Count
1765294017	359 Count	624 Count
1765292216	358 Count	623 Count
1765290416	357 Count	622 Count
1765288622	356 Count	595 Count
1765286821	355 Count	594 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)