K0FTT Automobiles

My position About ☰

reset

PA3GPU-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PA3GPU-9. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*
1765344362	52 Count	236 Count
1765340759	51 Count	234 Count
1765337156	50 Count	227 Count
1765333565	49 Count	225 Count
1765329962	48 Count	223 Count
1765326359	47 Count	221 Count
1765322756	46 Count	219 Count
1765311965	43 Count	208 Count
1765308363	42 Count	206 Count
1765304760	41 Count	204 Count
1765301157	40 Count	202 Count
1765297554	39 Count	200 Count
1765293951	38 Count	193 Count
1765290363	37 Count	191 Count
1765286760	36 Count	189 Count
1765283158	35 Count	166 Count
1765279555	34 Count	138 Count
1765275952	33 Count	136 Count
1765272349	32 Count	129 Count
1765268763	31 Count	127 Count
1765265161	30 Count	125 Count
1765261558	29 Count	123 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)