K0FTT Automobiles

My position About ☰

reset

SP5UID-4 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5UID-4. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1765460986	2 Count	157 Count
1765459189	1 Count	110 Count
1765457388	0 Count	54 Count
1765455587	17 Count	1035 Count
1765453785	16 Count	976 Count
1765452589	15 Count	933 Count
1765450788	14 Count	866 Count
1765448987	13 Count	789 Count
1765447185	12 Count	713 Count
1765444792	11 Count	628 Count
1765442991	10 Count	571 Count
1765441189	9 Count	529 Count
1765439388	8 Count	480 Count
1765437589	7 Count	438 Count
1765435788	6 Count	395 Count
1765433986	5 Count	326 Count
1765432185	4 Count	235 Count
1765430388	3 Count	197 Count
1765428586	2 Count	139 Count
1765426785	1 Count	95 Count
1765424984	0 Count	45 Count
1765423186	23 Count	1031 Count
1765421384	22 Count	983 Count
1765419583	21 Count	928 Count
1765417782	20 Count	878 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)