K0FTT Automobiles

My position About ☰

reset

AI0ET-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object AI0ET-9. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	Vaux*	Vmain*	Pi_temp*
1765317535	14.23 Volts	0.01 Volts	34 Deg.C
1765317474	14.27 Volts	0.01 Volts	34 Deg.C
1765317459	14.26 Volts	0.01 Volts	34 Deg.C
1765317374	14.29 Volts	0.01 Volts	34 Deg.C
1765317193	14.27 Volts	0.01 Volts	34 Deg.C
1765317177	14.27 Volts	0.01 Volts	34 Deg.C
1765317130	14.24 Volts	0.01 Volts	34 Deg.C
1765316904	14.29 Volts	0.01 Volts	32 Deg.C
1765316888	14.28 Volts	0.01 Volts	33 Deg.C
1765316800	14.07 Volts	0.01 Volts	33 Deg.C
1765316753	12.63 Volts	0.01 Volts	33 Deg.C
1765315421	12.57 Volts	0.02 Volts	28 Deg.C
1765314846	14.32 Volts	0.01 Volts	23 Deg.C
1765314830	14.32 Volts	0 Volts	24 Deg.C
1765314593	14.29 Volts	0.01 Volts	21 Deg.C
1765314406	13.89 Volts	0.01 Volts	15 Deg.C

*Used Equation Coefficients:

Vaux: 0, 0.01, 0

Vmain: 0, 0.01, 0

Pi_temp: 0, 1, 0

Value4: 0, 0, 0

Value5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)