K0FTT Automobiles

My position About ☰

reset

EA5GVP-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA5GVP-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Temp*	Pressure*	Humidity*
1765361945	158	8280	37
1765361345	158	8280	37
1765360745	158	8280	37
1765360145	158	8280	37
1765359545	158	8280	37
1765358945	158	8280	37
1765358345	158	8280	37
1765357745	158	8280	37
1765357145	158	8280	37
1765356545	158	8280	37
1765355945	158	8280	37
1765355345	158	8280	37
1765354745	158	8280	37
1765354145	158	8280	37
1765353545	158	8280	37
1765352945	158	8280	37
1765352345	158	8280	37
1765351745	158	8280	37
1765351145	158	8280	37
1765350545	158	8280	37
1765349945	156	8280	37
1765349345	158	8280	37
1765348745	158	8280	37
1765348145	158	8280	37
1765347545	158	8280	37

*Used Equation Coefficients:

Temp: 0, 1, 0

Pressure: 0, 1, 0

Humidity: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)