K0FTT Automobiles

My position About ☰

reset

SQ9SIM-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9SIM-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1765330017	5 Count	54 Count	4 Count
1765326435	414 Count	1039 Count	355 Count
1765322832	361 Count	938 Count	305 Count
1765319230	323 Count	866 Count	269 Count
1765315629	272 Count	775 Count	220 Count
1765312027	251 Count	712 Count	201 Count
1765308426	192 Count	596 Count	144 Count
1765304824	156 Count	499 Count	110 Count
1765301223	126 Count	419 Count	82 Count
1765297621	108 Count	395 Count	66 Count
1765294020	105 Count	384 Count	65 Count
1765290418	101 Count	382 Count	63 Count
1765286816	99 Count	382 Count	63 Count
1765283232	85 Count	370 Count	51 Count
1765279631	70 Count	354 Count	38 Count
1765276029	62 Count	348 Count	32 Count
1765272428	39 Count	321 Count	11 Count
1765268826	30 Count	292 Count	4 Count
1765265225	24 Count	287 Count	0 Count
1765261623	22 Count	287 Count	0 Count
1765258022	20 Count	256 Count	0 Count
1765254420	18 Count	226 Count	0 Count
1765250819	16 Count	183 Count	0 Count
1765247217	14 Count	128 Count	0 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)