K0FTT Automobiles

My position About ☰

reset

SP2SGK-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2SGK-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1765362363	463 Count	245 Count	230 Count
1765361528	461 Count	244 Count	229 Count
1765360625	459 Count	243 Count	228 Count
1765359722	457 Count	242 Count	227 Count
1765358819	455 Count	241 Count	226 Count
1765357916	453 Count	240 Count	225 Count
1765357013	451 Count	239 Count	224 Count
1765356110	449 Count	238 Count	223 Count
1765355207	447 Count	237 Count	222 Count
1765354303	445 Count	236 Count	221 Count
1765353401	443 Count	235 Count	220 Count
1765352497	441 Count	234 Count	219 Count
1765351594	439 Count	233 Count	218 Count
1765350691	437 Count	232 Count	217 Count
1765349788	435 Count	231 Count	216 Count
1765348885	433 Count	230 Count	215 Count
1765347982	431 Count	229 Count	214 Count
1765347079	429 Count	228 Count	213 Count
1765346177	427 Count	227 Count	212 Count
1765345274	425 Count	226 Count	211 Count
1765344371	423 Count	225 Count	210 Count
1765343468	421 Count	224 Count	209 Count
1765342565	419 Count	223 Count	208 Count
1765341662	417 Count	222 Count	207 Count
1765340759	415 Count	221 Count	206 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)