K0FTT Automobiles

My position About ☰

reset

SR2WH-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2WH-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1765454447	100 Count	141 Count	89 Count
1765452647	92 Count	129 Count	82 Count
1765450846	84 Count	117 Count	75 Count
1765449049	76 Count	105 Count	68 Count
1765447245	69 Count	95 Count	62 Count
1765445445	59 Count	82 Count	53 Count
1765443644	47 Count	67 Count	42 Count
1765441843	39 Count	55 Count	35 Count
1765440042	30 Count	43 Count	27 Count
1765438242	19 Count	28 Count	17 Count
1765436441	12 Count	19 Count	11 Count
1765434641	7 Count	10 Count	7 Count
1765432840	736 Count	1006 Count	631 Count
1765431039	728 Count	994 Count	624 Count
1765429238	720 Count	982 Count	617 Count
1765427437	712 Count	970 Count	610 Count
1765425637	703 Count	957 Count	602 Count
1765423836	696 Count	947 Count	596 Count
1765422035	689 Count	936 Count	590 Count
1765420234	683 Count	926 Count	585 Count
1765418434	673 Count	912 Count	576 Count
1765416633	665 Count	900 Count	569 Count
1765414833	658 Count	891 Count	563 Count
1765413032	649 Count	878 Count	555 Count
1765411231	639 Count	864 Count	546 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)