K0FTT Automobiles

My position About ☰

reset

SQ2WSZ-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2WSZ-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1765361047	268 Count	717 Count	124 Count
1765360146	266 Count	711 Count	123 Count
1765359245	265 Count	704 Count	123 Count
1765358345	264 Count	701 Count	123 Count
1765357444	263 Count	697 Count	123 Count
1765356581	258 Count	694 Count	123 Count
1765355680	257 Count	690 Count	123 Count
1765354779	256 Count	684 Count	123 Count
1765353879	255 Count	677 Count	123 Count
1765352977	254 Count	673 Count	123 Count
1765352076	253 Count	671 Count	123 Count
1765351176	252 Count	667 Count	123 Count
1765350275	251 Count	662 Count	123 Count
1765349374	250 Count	657 Count	123 Count
1765348473	249 Count	648 Count	123 Count
1765347573	248 Count	643 Count	123 Count
1765346672	247 Count	638 Count	123 Count
1765345771	235 Count	621 Count	112 Count
1765344871	233 Count	615 Count	111 Count
1765343970	232 Count	612 Count	111 Count
1765343069	231 Count	608 Count	111 Count
1765342168	230 Count	602 Count	111 Count
1765341268	229 Count	598 Count	111 Count
1765340367	228 Count	595 Count	111 Count
1765339466	227 Count	583 Count	111 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)