K0FTT Automobiles

My position About ☰

reset

SQ2MO-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2MO-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1765362872	165 Count	563 Count	89 Count
1765361672	164 Count	552 Count	89 Count
1765360481	159 Count	539 Count	89 Count
1765359280	158 Count	532 Count	89 Count
1765358080	157 Count	521 Count	89 Count
1765356879	155 Count	511 Count	88 Count
1765355678	154 Count	505 Count	88 Count
1765354478	153 Count	496 Count	88 Count
1765353277	152 Count	489 Count	88 Count
1765350876	147 Count	477 Count	85 Count
1765349675	145 Count	469 Count	84 Count
1765348475	143 Count	458 Count	83 Count
1765347274	141 Count	447 Count	82 Count
1765346073	139 Count	438 Count	81 Count
1765344873	138 Count	422 Count	81 Count
1765343672	135 Count	414 Count	79 Count
1765342472	133 Count	407 Count	78 Count
1765341271	131 Count	401 Count	77 Count
1765340070	128 Count	391 Count	75 Count
1765338880	122 Count	381 Count	74 Count
1765337680	120 Count	372 Count	73 Count
1765336479	117 Count	365 Count	71 Count
1765335279	115 Count	339 Count	70 Count
1765334078	113 Count	326 Count	69 Count
1765332878	110 Count	318 Count	67 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)