K0FTT Automobiles

My position About ☰

reset

SP6RGZ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6RGZ-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1765355706	387 Count	504 Count	46 Count
1765353905	386 Count	503 Count	46 Count
1765352104	385 Count	501 Count	46 Count
1765350310	384 Count	498 Count	46 Count
1765348509	383 Count	496 Count	46 Count
1765346708	382 Count	494 Count	46 Count
1765344908	381 Count	492 Count	46 Count
1765343107	380 Count	490 Count	46 Count
1765341306	379 Count	488 Count	46 Count
1765339505	378 Count	486 Count	46 Count
1765337705	377 Count	484 Count	46 Count
1765335904	376 Count	482 Count	46 Count
1765334103	375 Count	481 Count	46 Count
1765332303	374 Count	480 Count	46 Count
1765330502	373 Count	479 Count	46 Count
1765328710	372 Count	476 Count	46 Count
1765326909	371 Count	474 Count	46 Count
1765325108	370 Count	472 Count	46 Count
1765323307	369 Count	470 Count	46 Count
1765321507	368 Count	468 Count	46 Count
1765319706	367 Count	466 Count	46 Count
1765317905	366 Count	464 Count	46 Count
1765316104	365 Count	463 Count	46 Count
1765314304	364 Count	462 Count	46 Count
1765312503	363 Count	461 Count	46 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)