K0FTT Automobiles

My position About ☰

reset

SP7THR-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP7THR-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*
1765371083	157 Count	669 Count
1765369882	156 Count	661 Count
1765368694	155 Count	660 Count
1765367493	154 Count	660 Count
1765366292	153 Count	660 Count
1765365091	152 Count	660 Count
1765363891	151 Count	660 Count
1765362690	150 Count	660 Count
1765361489	149 Count	660 Count
1765360288	148 Count	660 Count
1765359088	147 Count	660 Count
1765357887	146 Count	660 Count
1765356686	145 Count	660 Count
1765355485	144 Count	660 Count
1765354284	143 Count	660 Count
1765353083	142 Count	660 Count
1765351883	141 Count	660 Count
1765350682	140 Count	660 Count
1765349481	139 Count	660 Count
1765348280	138 Count	647 Count
1765347094	137 Count	645 Count
1765345893	136 Count	645 Count
1765344692	135 Count	644 Count
1765343492	134 Count	644 Count
1765342291	133 Count	644 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)