K0FTT Automobiles

My position About ☰

reset

OK1OBR-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK1OBR-12. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1765369263	35 Count	25 Count	24 Count
1765367459	30 Count	21 Count	20 Count
1765365655	27 Count	18 Count	18 Count
1765363851	24 Count	16 Count	16 Count
1765362047	21 Count	14 Count	14 Count
1765360243	18 Count	12 Count	12 Count
1765358440	15 Count	10 Count	10 Count
1765356636	12 Count	8 Count	8 Count
1765354832	9 Count	6 Count	6 Count
1765353028	6 Count	4 Count	4 Count
1765351224	3 Count	2 Count	2 Count
1765349420	0 Count	0 Count	0 Count
1765345747	991 Count	624 Count	603 Count
1765343943	990 Count	624 Count	603 Count
1765342139	989 Count	624 Count	603 Count
1765340335	988 Count	624 Count	603 Count
1765338531	987 Count	624 Count	603 Count
1765336727	986 Count	624 Count	603 Count
1765334923	985 Count	624 Count	603 Count
1765327754	981 Count	624 Count	603 Count
1765325950	980 Count	624 Count	603 Count
1765324147	979 Count	624 Count	603 Count
1765322343	978 Count	624 Count	603 Count
1765320539	977 Count	624 Count	603 Count
1765318735	976 Count	624 Count	603 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)