K0FTT Automobiles

My position About ☰

reset

OK1FWG-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK1FWG-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1765379571	670 Count	583 Count	578 Count
1765377767	656 Count	571 Count	566 Count
1765375964	653 Count	569 Count	564 Count
1765374161	650 Count	567 Count	562 Count
1765372358	647 Count	565 Count	560 Count
1765370555	642 Count	563 Count	558 Count
1765368751	639 Count	561 Count	556 Count
1765366948	636 Count	559 Count	554 Count
1765365145	632 Count	556 Count	551 Count
1765363342	628 Count	554 Count	549 Count
1765361539	620 Count	547 Count	542 Count
1765359735	617 Count	545 Count	540 Count
1765357932	614 Count	543 Count	538 Count
1765356129	610 Count	541 Count	536 Count
1765354325	607 Count	539 Count	534 Count
1765352522	604 Count	537 Count	532 Count
1765350719	601 Count	535 Count	530 Count
1765348916	597 Count	533 Count	528 Count
1765347113	593 Count	530 Count	525 Count
1765345310	585 Count	523 Count	518 Count
1765343507	584 Count	523 Count	518 Count
1765341704	582 Count	523 Count	518 Count
1765339901	581 Count	523 Count	518 Count
1765338098	580 Count	523 Count	518 Count
1765336294	579 Count	523 Count	518 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)