K0FTT Automobiles

My position About ☰

reset

SP9LJE-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9LJE-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1765426591	236 Count	448 Count	140 Count
1765424791	234 Count	434 Count	139 Count
1765422989	231 Count	416 Count	137 Count
1765421188	228 Count	396 Count	135 Count
1765419387	225 Count	382 Count	133 Count
1765417586	222 Count	369 Count	131 Count
1765415786	220 Count	359 Count	130 Count
1765413994	217 Count	343 Count	128 Count
1765412193	215 Count	326 Count	127 Count
1765410392	214 Count	319 Count	127 Count
1765408591	213 Count	317 Count	127 Count
1765406791	212 Count	309 Count	127 Count
1765404990	210 Count	297 Count	126 Count
1765403189	208 Count	293 Count	125 Count
1765401389	207 Count	292 Count	125 Count
1765399588	206 Count	292 Count	125 Count
1765397788	205 Count	291 Count	125 Count
1765395987	203 Count	290 Count	124 Count
1765394186	200 Count	283 Count	122 Count
1765392400	197 Count	279 Count	120 Count
1765390599	194 Count	277 Count	118 Count
1765388797	192 Count	274 Count	117 Count
1765386996	190 Count	269 Count	116 Count
1765385196	188 Count	262 Count	115 Count
1765383395	186 Count	257 Count	114 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)