K0FTT Automobiles

My position About ☰

reset

SP5UID-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5UID-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*
1765465729	7 Count	824 Count
1765463988	6 Count	409 Count
1765462246	5 Count	255 Count
1765462011	4 Count	243 Count
1765460270	3 Count	165 Count
1765458529	2 Count	113 Count
1765456787	1 Count	59 Count
1765455046	0 Count	3 Count
1765454810	16 Count	1054 Count
1765453069	15 Count	988 Count
1765451327	14 Count	916 Count
1765449586	13 Count	833 Count
1765447845	12 Count	762 Count
1765447609	11 Count	754 Count
1765445868	10 Count	679 Count
1765444127	9 Count	616 Count
1765442385	8 Count	555 Count
1765440644	7 Count	483 Count
1765440411	6 Count	476 Count
1765438669	5 Count	413 Count
1765436928	4 Count	365 Count
1765435187	3 Count	313 Count
1765433445	2 Count	128 Count
1765433208	1 Count	114 Count
1765431467	0 Count	49 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)