K0FTT Automobiles

My position About ☰

reset

SQ9PD-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9PD-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1765361302	15 Count	127 Count	13 Count
1765357699	81 Count	975 Count	64 Count
1765356790	76 Count	911 Count	60 Count
1765355890	70 Count	856 Count	55 Count
1765354989	66 Count	815 Count	52 Count
1765354095	61 Count	773 Count	48 Count
1765353188	57 Count	721 Count	45 Count
1765351386	48 Count	581 Count	38 Count
1765350486	42 Count	537 Count	33 Count
1765346883	23 Count	298 Count	18 Count
1765345982	20 Count	245 Count	16 Count
1765345089	15 Count	170 Count	12 Count
1765340578	131 Count	994 Count	95 Count
1765318092	6 Count	37 Count	3 Count
1765317192	5 Count	34 Count	3 Count
1765316291	4 Count	31 Count	3 Count
1765315390	1 Count	8 Count	1 Count
1765314490	104 Count	1027 Count	70 Count
1765313589	100 Count	988 Count	67 Count
1765312687	95 Count	943 Count	63 Count
1765311787	90 Count	907 Count	59 Count
1765310886	87 Count	890 Count	57 Count
1765309985	83 Count	843 Count	54 Count
1765309085	81 Count	833 Count	53 Count
1765308184	80 Count	822 Count	53 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)