K0FTT Automobiles

My position About ☰

reset

SR2ST-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2ST-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1765349366	590 Count	346 Count	87 Count
1765346253	564 Count	332 Count	83 Count
1765344573	551 Count	325 Count	81 Count
1765342892	538 Count	318 Count	79 Count
1765341211	527 Count	311 Count	78 Count
1765339530	514 Count	304 Count	76 Count
1765337849	501 Count	296 Count	74 Count
1765336169	488 Count	288 Count	72 Count
1765334488	473 Count	281 Count	70 Count
1765332807	461 Count	273 Count	68 Count
1765331126	448 Count	266 Count	66 Count
1765329446	435 Count	258 Count	64 Count
1765327765	425 Count	251 Count	63 Count
1765326084	412 Count	244 Count	61 Count
1765324653	398 Count	237 Count	59 Count
1765322972	384 Count	229 Count	57 Count
1765321291	371 Count	222 Count	55 Count
1765319610	361 Count	215 Count	54 Count
1765317929	348 Count	208 Count	52 Count
1765316249	333 Count	200 Count	50 Count
1765314568	320 Count	192 Count	48 Count
1765312887	308 Count	185 Count	46 Count
1765311206	295 Count	177 Count	44 Count
1765309525	282 Count	170 Count	42 Count
1765307845	269 Count	162 Count	40 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)