K0FTT Automobiles

My position About ☰

reset

SR2CA-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2CA-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1765456387	74 Count	718 Count
1765454706	73 Count	704 Count
1765453024	72 Count	697 Count
1765451345	71 Count	687 Count
1765449664	70 Count	677 Count
1765447983	69 Count	669 Count
1765446302	68 Count	642 Count
1765444621	67 Count	634 Count
1765442941	66 Count	612 Count
1765439829	60 Count	590 Count
1765438147	59 Count	580 Count
1765436466	58 Count	572 Count
1765434785	57 Count	564 Count
1765433104	56 Count	552 Count
1765431424	55 Count	545 Count
1765429743	54 Count	535 Count
1765428062	53 Count	524 Count
1765426381	52 Count	514 Count
1765424700	51 Count	501 Count
1765423020	50 Count	491 Count
1765421339	49 Count	481 Count
1765418237	43 Count	462 Count
1765416556	42 Count	452 Count
1765414875	41 Count	444 Count
1765413193	40 Count	432 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)