K0FTT Automobiles

My position About ☰

reset

IU3ISP-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IU3ISP-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1765341174	174 Count	110 Count	110 Count
1765339370	171 Count	108 Count	108 Count
1765337566	168 Count	106 Count	106 Count
1765335762	165 Count	104 Count	104 Count
1765332154	160 Count	101 Count	101 Count
1765330394	153 Count	99 Count	99 Count
1765328590	150 Count	97 Count	97 Count
1765326786	148 Count	96 Count	96 Count
1765324983	145 Count	94 Count	94 Count
1765323179	142 Count	92 Count	92 Count
1765321375	139 Count	90 Count	90 Count
1765319571	136 Count	88 Count	88 Count
1765317767	134 Count	87 Count	87 Count
1765315964	131 Count	85 Count	85 Count
1765312356	125 Count	81 Count	81 Count
1765310552	122 Count	79 Count	79 Count
1765308792	115 Count	77 Count	77 Count
1765306988	113 Count	76 Count	76 Count
1765305184	110 Count	74 Count	74 Count
1765303380	107 Count	72 Count	72 Count
1765301576	104 Count	70 Count	70 Count
1765299772	101 Count	68 Count	68 Count
1765297968	97 Count	65 Count	65 Count
1765296164	88 Count	57 Count	57 Count
1765294361	83 Count	53 Count	53 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)