K0FTT Automobiles

My position About ☰

reset

SP9APJ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9APJ-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1765458953	193 Count	955 Count	171 Count
1765455352	133 Count	809 Count	113 Count
1765451751	103 Count	727 Count	85 Count
1765449950	85 Count	676 Count	68 Count
1765448150	63 Count	624 Count	47 Count
1765446349	49 Count	471 Count	34 Count
1765444548	45 Count	441 Count	31 Count
1765442748	42 Count	419 Count	29 Count
1765440950	39 Count	393 Count	27 Count
1765437352	28 Count	169 Count	22 Count
1765435552	25 Count	147 Count	20 Count
1765433751	22 Count	121 Count	18 Count
1765431951	19 Count	101 Count	16 Count
1765430150	14 Count	76 Count	12 Count
1765428349	8 Count	48 Count	7 Count
1765426549	3 Count	25 Count	3 Count
1765424748	235 Count	1023 Count	180 Count
1765422947	231 Count	1000 Count	177 Count
1765421147	227 Count	975 Count	174 Count
1765419346	220 Count	950 Count	168 Count
1765417552	212 Count	926 Count	165 Count
1765415751	208 Count	892 Count	162 Count
1765413951	204 Count	871 Count	159 Count
1765412150	196 Count	845 Count	152 Count
1765410349	189 Count	821 Count	146 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)