K0FTT Automobiles

My position About ☰

reset

SR2DTW-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2DTW-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1765462577	329 Count	540 Count	214 Count
1765460896	326 Count	535 Count	212 Count
1765459216	323 Count	530 Count	210 Count
1765457535	321 Count	526 Count	209 Count
1765455854	318 Count	521 Count	207 Count
1765454422	311 Count	517 Count	205 Count
1765452741	309 Count	507 Count	204 Count
1765451061	306 Count	502 Count	202 Count
1765449380	303 Count	496 Count	200 Count
1765447699	301 Count	492 Count	199 Count
1765446018	287 Count	475 Count	186 Count
1765444338	283 Count	469 Count	183 Count
1765442657	275 Count	459 Count	176 Count
1765440976	272 Count	449 Count	174 Count
1765439295	269 Count	445 Count	172 Count
1765437614	265 Count	439 Count	169 Count
1765435934	263 Count	435 Count	168 Count
1765434253	260 Count	430 Count	166 Count
1765432821	253 Count	426 Count	164 Count
1765431140	251 Count	418 Count	163 Count
1765429460	248 Count	413 Count	161 Count
1765427779	245 Count	408 Count	159 Count
1765426098	243 Count	404 Count	158 Count
1765424417	238 Count	397 Count	154 Count
1765422737	235 Count	392 Count	152 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)