K0FTT Automobiles

My position About ☰

reset

SP2OSA Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2OSA. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1765372137	27 Count	337 Count	2 Count
1765370336	26 Count	324 Count	2 Count
1765368535	25 Count	309 Count	2 Count
1765366735	24 Count	296 Count	2 Count
1765364941	19 Count	278 Count	2 Count
1765363141	18 Count	259 Count	2 Count
1765361340	17 Count	237 Count	2 Count
1765359539	15 Count	217 Count	1 Count
1765357738	13 Count	199 Count	0 Count
1765355938	12 Count	179 Count	0 Count
1765354137	11 Count	157 Count	0 Count
1765352336	10 Count	142 Count	0 Count
1765350536	9 Count	127 Count	0 Count
1765348735	8 Count	105 Count	0 Count
1765346934	7 Count	85 Count	0 Count
1765345134	6 Count	55 Count	0 Count
1765343340	1 Count	39 Count	0 Count
1765341540	0 Count	22 Count	0 Count
1765339739	99 Count	1009 Count	38 Count
1765337938	97 Count	988 Count	37 Count
1765336137	95 Count	971 Count	36 Count
1765334337	94 Count	926 Count	36 Count
1765332536	93 Count	910 Count	36 Count
1765330735	92 Count	896 Count	36 Count
1765328935	91 Count	872 Count	36 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)