K0FTT Automobiles

My position About ☰

reset

SV1SSF-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SV1SSF-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1765453185	802 Count	837 Count	286 Count
1765452280	799 Count	832 Count	285 Count
1765451374	794 Count	826 Count	283 Count
1765450468	789 Count	820 Count	281 Count
1765449563	784 Count	814 Count	279 Count
1765448657	780 Count	809 Count	278 Count
1765447751	776 Count	803 Count	276 Count
1765446845	771 Count	799 Count	274 Count
1765445940	750 Count	764 Count	255 Count
1765445034	746 Count	758 Count	254 Count
1765444128	730 Count	739 Count	240 Count
1765443222	724 Count	734 Count	237 Count
1765442317	720 Count	730 Count	236 Count
1765441411	716 Count	727 Count	235 Count
1765440505	713 Count	712 Count	234 Count
1765439600	708 Count	705 Count	232 Count
1765438694	704 Count	694 Count	231 Count
1765437788	701 Count	683 Count	230 Count
1765436883	697 Count	677 Count	229 Count
1765435977	693 Count	673 Count	227 Count
1765435071	689 Count	669 Count	226 Count
1765434165	686 Count	666 Count	225 Count
1765433260	682 Count	661 Count	224 Count
1765432354	678 Count	656 Count	222 Count
1765431449	674 Count	654 Count	221 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)