K0FTT Automobiles

My position About ☰

reset

SR2JP-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2JP-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1765430879	341 Count	908 Count
1765429198	340 Count	905 Count
1765427517	339 Count	902 Count
1765425838	338 Count	897 Count
1765424156	337 Count	894 Count
1765422475	336 Count	892 Count
1765420794	335 Count	889 Count
1765419114	334 Count	886 Count
1765417433	333 Count	883 Count
1765415752	332 Count	880 Count
1765409278	324 Count	865 Count
1765407597	323 Count	862 Count
1765405917	322 Count	859 Count
1765404235	321 Count	854 Count
1765402555	320 Count	851 Count
1765400874	319 Count	849 Count
1765399193	318 Count	846 Count
1765397512	317 Count	843 Count
1765395832	316 Count	839 Count
1765394151	315 Count	835 Count
1765392470	314 Count	832 Count
1765390789	313 Count	824 Count
1765389108	311 Count	822 Count
1765387678	307 Count	820 Count
1765385997	306 Count	817 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)