K0FTT Automobiles

My position About ☰

reset

SP9ZS-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9ZS-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1766916122	51 Count	423 Count	38 Count
1766915222	45 Count	366 Count	34 Count
1766914321	40 Count	318 Count	31 Count
1766913420	34 Count	256 Count	27 Count
1766912520	20 Count	180 Count	14 Count
1766911619	15 Count	128 Count	10 Count
1766910718	11 Count	87 Count	7 Count
1766909818	5 Count	36 Count	4 Count
1766908917	95 Count	1035 Count	63 Count
1766908016	90 Count	987 Count	60 Count
1766907116	85 Count	944 Count	57 Count
1766906215	79 Count	888 Count	53 Count
1766905315	74 Count	846 Count	50 Count
1766904414	68 Count	795 Count	47 Count
1766903513	64 Count	751 Count	45 Count
1766902613	60 Count	692 Count	43 Count
1766901712	57 Count	653 Count	42 Count
1766900811	51 Count	606 Count	38 Count
1766899911	46 Count	561 Count	35 Count
1766899025	42 Count	509 Count	32 Count
1766898124	38 Count	469 Count	29 Count
1766897224	33 Count	417 Count	25 Count
1766896323	29 Count	376 Count	22 Count
1766895422	24 Count	322 Count	18 Count
1766894522	20 Count	281 Count	15 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)