K0FTT Automobiles

My position About ☰

reset

SP2SGL-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2SGL-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1766792399	223 Count	252 Count	201 Count
1766790598	212 Count	240 Count	191 Count
1766783400	164 Count	191 Count	151 Count
1766781599	148 Count	173 Count	136 Count
1766779798	133 Count	156 Count	122 Count
1766777997	118 Count	137 Count	108 Count
1766776197	96 Count	111 Count	87 Count
1766774396	78 Count	91 Count	70 Count
1766772595	59 Count	69 Count	52 Count
1766768994	20 Count	22 Count	16 Count
1766764966	853 Count	985 Count	792 Count
1766763165	841 Count	970 Count	781 Count
1766761365	818 Count	946 Count	759 Count
1766759563	793 Count	919 Count	735 Count
1766757763	769 Count	891 Count	712 Count
1766755962	757 Count	878 Count	701 Count
1766754161	741 Count	858 Count	686 Count
1766752361	702 Count	808 Count	648 Count
1766750560	682 Count	784 Count	629 Count
1766748759	664 Count	761 Count	612 Count
1766746966	645 Count	743 Count	598 Count
1766745165	634 Count	732 Count	588 Count
1766743364	622 Count	715 Count	577 Count
1766741564	610 Count	698 Count	566 Count
1766739763	593 Count	677 Count	550 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)