K0FTT Automobiles

My position About ☰

reset

SP2HCA-14 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2HCA-14. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1765456755	524 Count	637 Count	393 Count
1765454955	521 Count	635 Count	391 Count
1765453154	518 Count	633 Count	389 Count
1765451353	515 Count	630 Count	387 Count
1765449553	513 Count	629 Count	386 Count
1765447755	510 Count	627 Count	384 Count
1765445952	502 Count	619 Count	377 Count
1765444151	498 Count	616 Count	374 Count
1765442351	495 Count	614 Count	372 Count
1765440550	490 Count	609 Count	368 Count
1765438749	479 Count	599 Count	358 Count
1765436948	473 Count	595 Count	354 Count
1765435154	465 Count	590 Count	350 Count
1765433354	460 Count	586 Count	346 Count
1765431553	455 Count	582 Count	342 Count
1765429752	450 Count	578 Count	338 Count
1765427952	445 Count	574 Count	334 Count
1765426151	440 Count	570 Count	330 Count
1765424350	432 Count	563 Count	323 Count
1765422550	428 Count	560 Count	320 Count
1765420749	423 Count	556 Count	316 Count
1765418949	418 Count	552 Count	312 Count
1765417148	413 Count	548 Count	308 Count
1765415564	407 Count	544 Count	304 Count
1765414698	403 Count	544 Count	304 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)