K0FTT Automobiles

My position About ☰

reset

UN9GIE-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object UN9GIE-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1766050009	456 Count	890 Count
1766049405	455 Count	890 Count
1766048801	454 Count	887 Count
1766048197	453 Count	887 Count
1766047594	452 Count	885 Count
1766046990	451 Count	882 Count
1766046387	450 Count	880 Count
1766045783	449 Count	879 Count
1766045180	448 Count	876 Count
1766044577	447 Count	875 Count
1766043973	446 Count	873 Count
1766043370	445 Count	870 Count
1766042766	444 Count	868 Count
1766042163	443 Count	867 Count
1766041560	442 Count	865 Count
1766040956	441 Count	863 Count
1766040353	440 Count	862 Count
1766039749	439 Count	859 Count
1766039146	438 Count	857 Count
1766038543	437 Count	856 Count
1766037939	436 Count	854 Count
1766037336	435 Count	852 Count
1766036732	434 Count	850 Count
1766036129	433 Count	848 Count
1766035526	432 Count	847 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)