K0FTT Automobiles

My position About ☰

reset

SP2WM-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2WM-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1765378557	575 Count	140 Count	139 Count
1765377656	574 Count	140 Count	139 Count
1765376756	573 Count	140 Count	139 Count
1765375872	568 Count	140 Count	139 Count
1765374971	567 Count	140 Count	139 Count
1765374071	566 Count	140 Count	139 Count
1765373170	565 Count	140 Count	139 Count
1765372269	564 Count	140 Count	139 Count
1765371368	563 Count	140 Count	139 Count
1765369567	561 Count	140 Count	139 Count
1765367765	559 Count	140 Count	139 Count
1765366864	558 Count	140 Count	139 Count
1765365963	557 Count	140 Count	139 Count
1765365063	556 Count	140 Count	139 Count
1765364162	555 Count	140 Count	139 Count
1765361460	552 Count	140 Count	139 Count
1765360559	551 Count	140 Count	139 Count
1765359658	550 Count	140 Count	139 Count
1765358758	549 Count	140 Count	139 Count
1765356956	547 Count	140 Count	139 Count
1765355154	545 Count	140 Count	139 Count
1765354271	540 Count	140 Count	139 Count
1765353370	539 Count	140 Count	139 Count
1765349767	535 Count	140 Count	139 Count
1765335355	519 Count	140 Count	139 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)