K0FTT Automobiles

My position About ☰

reset

SK3VJ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SK3VJ-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1765339575	221 Count	747 Count	193 Count
1765337772	209 Count	709 Count	182 Count
1765335969	194 Count	669 Count	168 Count
1765334167	182 Count	636 Count	157 Count
1765332397	165 Count	600 Count	145 Count
1765330594	151 Count	565 Count	132 Count
1765328791	136 Count	522 Count	118 Count
1765325185	108 Count	451 Count	92 Count
1765323382	94 Count	414 Count	79 Count
1765321579	82 Count	379 Count	68 Count
1765319776	75 Count	347 Count	62 Count
1765317973	67 Count	317 Count	55 Count
1765316170	59 Count	287 Count	48 Count
1765312564	45 Count	225 Count	36 Count
1765308993	27 Count	169 Count	24 Count
1765307187	19 Count	136 Count	17 Count
1765305384	14 Count	86 Count	13 Count
1765303581	6 Count	40 Count	6 Count
1765299974	228 Count	985 Count	194 Count
1765298171	214 Count	932 Count	181 Count
1765296368	208 Count	896 Count	176 Count
1765294565	200 Count	860 Count	169 Count
1765292763	181 Count	794 Count	151 Count
1765290959	173 Count	762 Count	144 Count
1765289190	162 Count	721 Count	138 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)