K0FTT Automobiles

My position About ☰

reset

OK4RS-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK4RS-12. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1765342678	789 Count	14 Count	13 Count
1765340887	788 Count	14 Count	13 Count
1765339086	787 Count	14 Count	13 Count
1765337285	786 Count	14 Count	13 Count
1765335485	785 Count	14 Count	13 Count
1765333684	784 Count	14 Count	13 Count
1765331883	783 Count	14 Count	13 Count
1765330082	782 Count	14 Count	13 Count
1765328281	781 Count	14 Count	13 Count
1765326481	780 Count	14 Count	13 Count
1765324680	779 Count	14 Count	13 Count
1765322879	778 Count	14 Count	13 Count
1765321078	777 Count	14 Count	13 Count
1765319286	776 Count	14 Count	13 Count
1765317486	775 Count	14 Count	13 Count
1765315685	774 Count	14 Count	13 Count
1765313884	773 Count	14 Count	13 Count
1765312083	772 Count	14 Count	13 Count
1765310282	771 Count	14 Count	13 Count
1765308481	770 Count	14 Count	13 Count
1765306681	769 Count	14 Count	13 Count
1765304880	768 Count	14 Count	13 Count
1765303079	767 Count	14 Count	13 Count
1765301278	766 Count	14 Count	13 Count
1765299477	765 Count	14 Count	13 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)